43
14.
The program can now be closed.
15.
Switch off Softcontrol Data/F or disconnect from the power supply.
16.
The jumper removed in point 4 must be put back in the same position.
17.
Remove the USB cable from Softcontrol Data/F and reinsert the USB stick.
18.
After switching on the supply voltage again, the system is ready for operation with the new
software.
15.
Device accessories
4 m flexible pressure-proof PA line 4 mm OD / 2 mm ID (sampling hose)
2 m flexible pressure-proof PA line 15 mm OD / 11.5 mm ID (drainage hose)
2 screw connections 4 mm x ¼“ IT
2 pieces of pre-filter connection 4 mm / 4 mm, 100 µm
1 piece USB2.0 stick 4GB
1 piece hardness sensor type 630
The mounting material for wall mounting must be provided by the customer!
Consumables that require serial numbers are listed below:
1 piece hardness sensor type 630
16
17
