20
10.3.
Control unit and display in measuring mode
Control unit
Softcontrol Data/F is parameterized via the control unit and the measurement results and ope-
rating modes are read. Parameterization and menu control are carried out using four buttons.
The measurement result and device status are shown in the illuminated display. In addition,
there are three LEDs for operating and fault signaling in the upper area:
Button functions:
4 Buttons
Display
LED display:
green LED
readiness display, flashes cyclicyally
(goes out every 5 seconds for 1 second each time)
yellow LED
-
flashes
measurement in raw water
red LED
-
lights up
alarm display device (sensor) alarm
-
flashes
limit value exceeding
LEDs
Activation of main menu
and confirmation after selection
Selection decreasing
Selection increasing
Leave the current menu item
without change
