3.7
Connecting the TURBOTRONIK
Use the connector cable to attach the
TURBOVAC
and the
TURBOTRONIK
;
see the operating instructions on the
TURBOTRONIK
for details.
Risk of injury!
Dangerous voltages are present at the mains connections. Before begin-
ning with any maintenance or service work on the pump, disconnect the
pump from all power supplies.
Operate the pump only with the matching frequency converter and
connector line.
Voltages of up to 400 V will be present at the connection cable between
the frequency converter and the pump; mains voltage will be present at
the fan, the flange heater, the valves and their supply leads.
Route the conductors and cables so as to protect them from damage.
The connections are of the IP 40 safety classification. Do not expose the
pump, frequency converter or connectors to dripping water.
The TURBOVAC
35 LS
and
35 LS2
are special pumps designed specifically
for leak detectors. These pumps
must not
be operated in connection with
the standard frequency converters NT 10, NT 12 or NT 13 (P/N 859 00 /01
/04 /05 /06 /07) or the standard cables for the TURBOVAC 50. For the TUR-
BOVAC 35 LS and 35 LS2 exclusively the modified frequency converter SO-
NT 12 (Ref. No. 200 99 042) and the corresponding cable (Ref. No. 200 61
626) must be used.
Installation
23
GA05118_1502 - 12/2006 - © Oerlikon Leybold Vacuum
Warning
