OE Max Controls CSDP Plus, Руководство пользователя

Страница: 57 / 254

59
For instance, put 7 in the fourth digit of SEt-59 to allocate the/P-CON
signal to the DI#7 pin.
Put 3 in the second digit of SEt-62 to allocate the /INHIB signal to DI#3
pin.
When 9 is set, it is always valid and when 0 is set, it is always invalid.
For instance, to keep SV-ON always valid when the power is on
regardless of the wiring, put 9 in the first digit of SEt-59.
Put 1 in the first digit of SEt-76 to allocate /P-COM signal to the DO#1
pin.
Put 3 in the fourth digit of SEt-77 to use /WARN function through DO#3
pin.
Setting 0 makes the system always invalid and there is no value to
make the system always valid, which is different from the input case.
If the warning in the diagram is displayed, it means
two or more signals were allocated to a single pin.
Output Signal Assignment Table
Parameter Fourth digit Third digit Second digit First digit
SEt-76 /V-COM /BK /TG-ON /P-COM
SEt-77 /WARN /NEAR /V-LMT /T-LMT
ATTENTION
Restart servo drive after signal assignment.