Basics
8
www.ocularrobotics.com
Ocular Robotics Ltd
Figure 2.5 Wiring and connections for the REV25-ST System
3.
Make sure the 24 volt power supply is switched OFF. Connect the supplied power
cable to the 24 volt power supply. On the unterminated end of the cable you will find
two wires one black and one with a red sheath on it. The black wire should be
connected to the negative terminal on the power supply. The cable with the red
sheath should be connected to the positive terminal on the power supply. The green
and yellow cable should be connected to a ground reference.
WARNING
- Make sure the power supply is not powered before
connecting the cables.
4.
Connect the power supply cable to the corresponding plug on the REV25-ST system.
Ensure the correct orientation by aligning the polarisation keys on the panel
connector and the plug. If forced in the incorrect orientation, damage to the system
is likely to result. Refer to Section 3.2.2 - Power for further details.
5.
If your REV25-ST VISION - STABILIZED System was ordered complete with an Allied
Vision Technologies camera then your system should be ready to use. For adjusting
the Focus and Aperture of your camera see Section 3.5.3 - Camera Focus and
Aperture. Otherwise follow steps a) to i) to install your chosen camera.
