Octave V 110 SE, Руководство пользователя

Страница: 11 / 38

12
3. GETTING STARTED
3.5. Checking the power tubes – setting the BIAS
Turn the mode selector knob clockwise to position 6 = BIAS. The input LEDs will extinguish.
Five LEDs will now illuminate: The power LED and the 4 BIAS LEDs in the center of the display,
one for each power tube. If the amplifier is still cold, the LEDs will initially illuminate "yellow".
Please wait five to ten minutes.
Please don't turn the BIAS regulators until the Soft-Start-LED is extinguished.
(
Because the tubes are still cold you would adjust the wrong BIAS)
After an additional 5 to 10 minutes, the BIAS control LEDs will change from yellow to green. This
indicates the correct bias and the unit is ready. If you notice any irregularity in the display please
refer to chapter 7.3.
3.6. Connecting other components to the V 110 SE
Procedure


Be sure to switch off the V 110 SE again!
 Connect the other components in your system to the appropriate sockets on the rear of the
V 110 SE. (See chapter 5 "Rear panel connections". See also chapter 3.7. "Connection
options: overview")
 Check that the switch positions on the front and rear of the amplifier are in their
recommended settings.

Switch on the V 110 SE using the on/off switch and wait until the Soft-Start LED
extinguishes. Now you can play music