Octave TouchTunes MX-1, Руководство по установке

Страница: 15 / 84

Prepare to Install OS2 Upgrade Kits
Workflow
OS2 Upgrade Kit Installation Guide
9
2.4.2 Power Supply Unit Upgrade Kit Components
This portion of the OS2 Upgrade Kit is only applicable to TouchTunes jukeboxes equipped with an MJS computer or
a JCB + for MJS computer. It is not needed when replacing a JCB or JCB + for JCB computer. The OS2 Upgrade Kit
(P/N 600304-001) should contain the following components:
2.5 Workflow
The procedures described here represent a logical sequence of events and best practices for installing your OS2
Upgrade Kit within the least time and with minimum difficulty.
In general, the basic procedures are:
1. Disconnection and removal of old computer.
The existing computer must be removed from the jukebox in order to accommodate the OS2 Upgrade Kit.
2. Installation of new components.
This procedure involves assembly, installation, and connection of the new TouchTunes components in the
jukebox.
3. Activation of the upgraded jukebox.
This procedure allows you to verify the success of your installation. See section 5 Activate the Jukebox .
Procedures for each jukebox that are in scope for upgrade are described in detail in the following sections:
• 3 Install OS2 Upgrade Kit in MX-1
• 4 Install OS2 Upgrade Kits in Allegro
Component
Quantity Component Description TouchTunes P/N
1 ASY, PSU BRACKET Mounting bracket for the Power
Supply Unit 401694-001
4 FAS, SCR, X-PAN, SEMS, M4X6,
ZN Zinc screws (size 4 x 6) 200244-006
1 HAR, PSU, EXTENSION CABLE,
14" Extension cable 14" to connect
power from PSU to computer-I/O
Board mounting bracket 301095-014
1 HAR, POWER CORD A/C,
ANGLED, 36" A/C power cord 36" 301097-036
CAUTION : Do not attempt installation if any jukebox hardware component or item in
the OS2 Upgrade Kit(s) is damaged. Contact TouchTunes to report the damage
immediately and request replacement parts.