Octagon SF 1028P HD - Noblence, Руководство пользователя

Страница: 47 / 84

47
3.1 Dish Setting

Select the satellite/antenna and LNB settings for service search.
The values that are set in this menu will be available for
selection in other service searching menus.
 Satellite :
Select the satellite which you want to do a search for.
- Press the
LEFT/RIGHT ARROW
button to select the satellite.
- If you press the OK button, the entire satellite list will be
displayed.
- Select the desired satellite name to search.
- If the desired satellite name is not listed then select User Defined.

Tuner Connection : You can set connection type, Separate or Loop-Through.
NOTE : Tuner Connection menu is disabled if tuner is not connected in twin satellite
or only one tuner is connected.
- Separate : Set the connection type option to
‘Separate’
, if each of the tuners are connected to
different LNBs (TUNER 1 / TUNER 2) individually / independently. This Separate connection is used,
when each two tuners are connected to different LNBs. Due the independent & separate
connections between two Tuners & LNBs, user can watch all the services scanned by one
TUNER 1
,
while the other
TUNER 2
is set for recording at the same time.
- Loop-Through : Set the connection type option to
‘Loop-Through’
, if you have connected the LNB
OUT (TUNER 1) and LNB IN (TUNER 2) with a loop-through cable. In this case, you would have some
limitations in using some features such as dual recording.
This connection is used when the
TUNER 1
is connected with LNB output, and the Loop-through
output of the
TUNER 1
is connected with input of the
TUNER 2.
This is the way to use & activate
both tuners when you have only 1 LNB with your dish antenna. However, this will limit the possible
tuning range (Satellite & Polarization) of the 2nd tuner, while the 1st tuner is being used for its
recording process (Because the input signal of 2nd tuner is dependent of the signal which the 1st
tuner is tuned to).
NOTE : User should make the appropriate connection by choosing the right tuner connections
between the Loop-Through and Separate connections. Due to the difference of these
two connections, wrong LNB and Tuner connection may cause the loss of signal
reception. We strongly recommend the use of professional service personnel to make
this installation and connection if your knowledge is limited.
 Tuner :
Select the tuner which you want to set (Tuner 1/ Tuner 2). If you set
‘Loop-Through’
on the
menu
(Installation-Dish Setting-Tuner Connection),
this menu(Tuner) will be disabled automatically.
 Frequency :
Select the satellite frequency which you want to use for checking the signal.
 LNB Power :
Select the LNB power on or off.
 LNB Type :
Select the LNB type.
 LNB Frequency :
Select the local oscillator (L.O.). frequency that is specified for the LNB used.
- Use the LEFT/RIGHT ARROW buttons to select the LNB frequency.
- If the required LNB frequency is not listed, then enter the frequency manually using the NUMERIC
buttons.
- When you select Universal LNB type, both 9750 and 10600 are supported at the same time. And
then the LNB 22KHz setting is disabled.
 LNB 22KHz :
When you use a separate coax 22 KHz tone switch box, make the 22 KHz tone switch
enabled or disabled to select the input you desire of the tone switch.
 DiSEqC Switch :
If you use DiSEqC 1.0 or DiSEqC 1.1 switch, select one of the DiSEqC inputs.