Ochsner OLWI 9, Инструкция по эксплуатации и установке

Страница: 11 / 48

BA_OLW I OTE3_SW5x_EN_20160815_V2 11 / 48
6.4 Bleeding the heating system
1
Automatic air-vent
Fig.10: Bleeding the heating system
► Bleed the pipework system carefully
► Operate the automatic air vent on the appliance
6.5 Condensate drain
A condensate drain hose is attached to the de-icing
sump The condensate drain hose is in the compressor
space on delivery.
►
Make sure that the condensate hose is not bent.
► Install the hose with a constant slope downwards.
► If the slope is not sufficient, a suitable condensate
pump must be installed Take the constructional fac-
tors into consideration.
► When using a condensate pump, make sure that its
rating is at least 6l/min.
Condensate drain:
1 Drain with odour trap
2
Drain hose with continuous gradient
3 Condensate drain connection
Fig.11: Condensate drain
Condensate drain with a condensate pump
1 Screed and floor covering
2 Footfall sound insulation
3 Condensate drain pipe
4 Plinth
Fig.12: Condensate drain with a condensate pump
The condensate drain hose can be led out of the appli-
ance to the left or the right through the "Durchführung
Kondensatablauf" (condensate drain feed through)
Dimensions in mm
1
Breakout plate for condensate drain
Fig.13: Breakout plate for condensate drain