INSTALLATION | Maintenance and care
10
www.ochsner.com | BIA-EUROPA Mini IWPL-EN11
5. Maintenance and care
We recommend having your heat pump inspected annu-
ally and, if necessary, serviced by OCHSNER Customer
Service.
Material damage
Maintenance work on electrical components of the
heat pump may only be carried out by qualified
contractors.
»
If it is necessary to clean the casing sections of the
appliance, use only a damp cloth (with water or a
weak soapy solution). Do not use any abrasive or ag-
gressive cleaning materials.
»
If the casing sections are heavily soiled, use methyl
alcohol.
6. Problem solving
The digital control unit displays any occurring faults. (See
If a fault occurs, contact your system installer. The system
installer knows your hydraulic system and how it operates.
The causes of faults can often be found in the settings or
in the hydraulics.
Before contacting the installer, make a note of the seri-
al number and the heat pump model. The serial number
and heat pump model of your appliance are shown on the
name plate. The name plates are attached to the upper
right-hand casing section of the heat pump on the rear of
the appliance.
INSTALLATION
7. Safety
Only a qualified contractor should carry out installation,
commissioning, maintenance and repair of the appliance.
7.1 General safety information
We guarantee trouble-free function and operational reliabil-
ity only if the original accessories and spare parts intended
for the appliance are used.
7.2 Regulations, provisions and standards
Information
Observe all applicable national and regional regu-
lations and provisions.
8. Appliance description
8.1 Scope of delivery
The scope of delivery of your appliance includes the fol-
lowing components.
►
Hot water heat pump EUROPA Mini IWPL
►
2 wall brackets (525 mm height x 700 mm projection)
incl. rubber pads
►
Sensor pocket
►
1 cable temperature sensors
8.2 Heating coil
Connecting the heat pump to a coil is generally not permit-
ted! However, the heat pump can be connected if the coil
(heat exchanger) is appropriately sized.
9. Preparing to install the
appliance
Before installing the appliance, preparatory work needs to
be carried out by qualified contractors.
