Ochsner AIR FALCON 212 C11A T200, Руководство по проектированию и установке

Страница: 20 / 68

20 www.ochsner.com | 00_200_202_08_01_002-EN
Machine-specific engineering and preparation
8. Machine-specific engineering
and preparation
Material damage
Air pressure and air humidity will affect the opera -
tional reliability of the electrical components in the
heat pump system (dielectric strength).
»
Observe the maximum installation altitude of
the heat pump system.
Unit Max. installation altitude (above
sea level)
AIR FALCON
212
m 2000
8.1 Outdoor unit
8.1.1 Installation location
► The outdoor unit must not be surrounded by walls/
objects on all four sides.
► The outdoor unit must not be positioned immediately
adjacent to walls/objects on one, two or three sides.
Material damage
The outdoor unit must be positioned so that the
air flow is not blocked by accumulation of snow
in winter.
»
Take into account the expected depth of snow
at the installation site and position the outdoor
unit at a sufficient height above the ground.
»
If necessary, construct a canopy above the
outdoor unit to protect it from any large accu-
mulation of snow.
»
Make sure that snow falling at the sides does
not damage the outdoor unit. If necessary
install a deflection plate to divert the snow.
When doing so, observe the machine-specific
minimum clearances.
► When installing the outdoor unit, the expected wind
direction must be taken into account.
1 Wind direction
► The outdoor unit should be positioned with the air
outlet side facing a wall, ensuring that minimum clear-
ances are observed; this protects the air outlet side
from direct exposure to winds.