OCEM DIAM3200 IGBT, Руководство по эксплуатации и обслуживанию

Страница: 29 / 58

ADJUSTMENTS AND
MAINTENANCE
UT-MT-0938_1.0_30-03-2023 (EN)
Use and Maintenance Manual
DIAM3200
29
4 ADJUSTMENTS AND MAINTENANCE
After completing the installation, check that all the fixed guards are closed.
Only now is possible to close the upstream cut-out to supply the device.
4.1 Preliminary operations
Act on the local cut-out (thermal-magnetic circuit breaker CB - standard), by rotating it in ON position.
When the device is ONLINE (constant current regulator powered) the display switches on, the system is initialized and
the device will revert to STOP mode: the controller’s control system is active, but the series circuit is disconnected.
During operation, the display always shows the output current (1) and a second parameter
(2) selectable as desired by the user: <Bx> level of brightness, output power Po (in kVA),
output voltage Uo (in V).
The parameter selection can be made when the constant current regulator is in STOP mode
by prolonged pressure on the STOP button (P1).
The device is provided already configured with the default values.
All the parameters can be freely customised on the basis of the customer needs.