CONTROLLER
KITs
.
2021 INSTALL & OPERATION MANUAL
7
2.5 FINALISE YOUR INSTALLATION (PRO SERIES)
Always test the system BEFORE the boat goes back into the water. Typical OceanLED light installs require
the boat to be hauled out of the water to replace light units.
The DMX standard recommends a maximum of 32 devices to be connected in one chain. If installation
requires more lights than this, please contact OceanLED for advice.
4. If Wi-Fi is required connect Ethernet cable from back of controller panel into a suitable Wi-Fi router or Wi-Fi
enabled network. (The controller is DHCP enabled as standard so should be detected by the network once
powered).
5. Connect the DMX controller DMX output cable to the DMX input of the first driver box. The DMX output of this
box should be connected to the input of the next, and so on up to the last driver in the chain.
6. Fit the supplied terminator to the output of the last driver box. See the following example of the connections:
