OceanDMX RC
.
2021 INSTALL & OPERATION MANUAL
7
2
Installation
To understand the system connections / layout required for the install please refer to the relevant installation sections
later in this chapter. These are either sections 2.5, 2.6 or 2.7, depending on the kit purchased. Then follow the sections
below to install the applicable units.
2.1 FINDING THE MOUNTING LOCATION
When choosing a mounting location for the DMX Controller the following recommendations need to be followed:
1. The unit should be mounted as high as possible in the vessel, and away from metal objects to ensure good radio
reception. Avoid areas surrounded by metallic insulation or coverings as this may interfere or restrict the radio
signals.
2. Consider the wiring routing / connections:
•
The distance to the 12 / 24 V DC power source and suitable cable gauge (please refer to section
5
Appendix
for cable gauge chart)
•
S
pace for the routing of the DMX cable to the drivers/ lights
3. Select flat surface in a dry location away from sources of heat, ensure the unit will not be exposed to moisture.
Ensure that the ambient temperature where the unit is mounted cannot exceed 50°C - Note that engine
compartments can easily exceed this.
2.2 ADDITIONAL TOOLS AND MATERIALS REQUIRED
•
Drill & Drill Bits.
•
Screwdriver, Phillips #2
•
Wire Strippers.
•
Tape measure and Ruler or Straight Edge.
•
Marking Utensil (e.g., Pencil, Sharpie Magic Marker)
•
Power switch with correct current rating for system
•
Power relay with correct current rating (recommended for most installations
– see below)
•
Fuse/holder to protect DMX receiver power wiring (500mA recommended).
2.3 DMX RECEIVER INSTALLATION
Once a suitable location has been found, use the following steps to mount the unit:
1. Unscrew the 4 case screws on the box and remove the lid.
2. The mounting holes for the unit are located inside the box, near to each corner - see diagram below.
