EXPLORE
E3
.
2021 INSTALL & OPERATION MANUAL
3
1
Installation Checklist
1.
Decide on light spacing
– OceanLED recommendations available.
Rear of lights must never be exposed to wet environments inside the hull.
2.
Ensure correct cable gauge is used (refer to relevant cable gauge chart).
3.
Correct length light fixture chosen (Extension kit required for hulls thicker than 55mm).
4.
Preparing the hull (Isolation kit required for conductive hull materials or wooden hulls).
5.
Make sure the lights have been fitted following the correct reflector orientation.
6.
Correct marine sealant applied evenly around bezel.
Ensure fully watertight seal is created after sealant cures.
7.
Correct clamping of light fixture onto hull. Never leave vessel unchecked for a few days after install.
Always check routinely for a few days after installation to ensure the install is correct and fully
sealed.
8.
Light(s) correctly bonded and vessel bonding system check carried out (refer to relevant schematic
and test procedures).
9.
Test installation BEFORE entering water. Never connect/ disconnect lights whilst powered ON.
Never leave lights ON out of water for longer than 5 minutes followed by an off period of 1 hour.
10.
Troubleshooting if required - most issues can be resolved by following the guidelines.
