Oceanled E6 TH, Руководство по установке и эксплуатации

Страница: 20 / 40

EXPLORE E6 & E7 TH .
INSTALL & OPERATION MANUAL
19
4.4 CONTROL SYSTEM INSTALLATION
Switch Control
Additional items required not supplied by OceanLED:
•
Push switch (Normally open, momentary type).
To use Switch Control, the Explore Control Input Cable and Terminator Kit is required.
To connect the lights to enable control of all lights using a single switch, Explore Control Link Cables must
be used. The quantity of Control Link Cables required per installation is equal to the number of lights minus
1 (Example: If 10 lights are used, 9 control link cables are required). Please consult the Explore TH Light
Choice Diagram in the Appendix (Section 7.3) for details.
Ensure power is disconnected before attempting to connect or solder any wire.
1. Connect one contact of the switch to the red wire of the Explore Input Control Cable. Connect the black
(Ground), yellow (DMX +) and brown (DMX -) wires together and connect to the other contact of the switch:
2. Plug the Switch cable to the
‘Control In’ Connector of the first driver.
3. Using the Control Link Cable, connect the
‘Control Out’ of the first driver to ‘Control In’ of the next driver. Repeat
until all the drivers are connected. Check the diagram below for clarification.
4. Plug the Explore Terminator to the
‘Control Out’ of the last driver.
5. Test the light units BEFORE the vessel goes into the water.
Control Switch Connection Diagram Example
Driver 2 Driver 3
Control Link
Cable
Control Link
Cable
Momentary
Switch
Te
rm
in
at
o
r
Driver 1
C
o
n
tr
o
l O
u
t
C
o
n
tr
o
l I
n
C
o
n
tr
o
l I
n
C
o
n
tr
o
l O
u
t
C
o
n
tr
o
l O
u
t
C
o
n
tr
o
l I
n
Momentary
Switch