Ocean Optics MFPF100-1, Инструкция по установке и эксплуатации

Страница: 15 / 26

1: Introduction
9. Click Yes . The Install Driver screen appears. Click Install to install the USB to UART Bridge
Controller Driver Set to the location shown on the screen, or browse to another location. A message
appears informing you that your installation is complete.
10. Click OK , then click Finish . You have now installed both OOISensors and MFPF software. You
must restart your computer to use the software.
Access MFPF software with the icon on your desktop. Access OOISensors software Start | All
Programs | Ocean Optics | OOISensors | OOISensors . If you attempt to start OOISensors software
without first starting the MFPF software, an error message appears.
Hardware Installation
WARNING
Ensure that the red plastic caps are covering the four SMA connectors on the front of the
MFPF unit. Intense UV radiation is emitted form the LEDS when the unit is powered-up.
Do NOT look directly at the LED output with the naked eye.
► Procedure
1. Unpack the equipment and verify that you have all the necessary components (see Shipment
Components and Additional Recommended Equipment ).
2. Connect thermistor(s) to T1 and T2 (for Model MFPF100-2) connectors on front of unit.
3. Locate the 21-02 SMA Splice Bushing that came with the probe. This item is a 0.75" screw with
two female ends. Screw one end of the splice bushing into the SMA 905 connector on the end of
the probe.
4. Locate the bifurcated fiber that came with the system. This optical fiber assembly has a “Y”
shaped design. Connect the common end of the bifurcated fiber to the splice bushing/probe.
MFPF-00000-000-02-0606 7