background image

In this mode, the fan will continue to

run for 3 minutes after the compressor

shuts off. The fan then cycles on for 2

minutes at 10 minute intervals until the

room temperature is above the set

temperature, at which time the 

compressor turns back on and cooling 

starts.

NOTE:

- The device could comply with the local national regulations. In Canada,

  it should comply with CAN ICES-3(B)/NMB-3(B). In USA, this device

  complies with part 15 of the FCC Rules. Operation is subject to the

  following two conditions: (1) This device may not cause harmful 

  interference, and (2) this device must accept any interference received,

  including interference that may cause undesired operation.
- This equipment has been tested and found to comply with the limits for

  a Class B digital device, pursuant to part 15 of the FCC Rules. These

  limits are designed to provide reasonable protection against harmful

  interference in a residential installation. This equipment generates, 

  uses and can radiate radio frequency energy and, if not installed and 

  used in accordance with the instructions, may cause harmful 

  interference to radio communications. However, there is no guarantee 

  that interference will not occur in a particular installation. If this 

  equipment does cause harmful interference to radio or television 

  reception, which can be determined by turning the equipment off and 

  on, the user is encouraged to try to correct the interference by one or 

  more of the following measures:

● Reorient or relocate the receiving antenna.

● Increase the separation between the equipment and receiver.

● Connect the equipment into an outlet on a circuit different from that to

   which the receiver is connected.

● Consult the dealer or an experienced radio/TV technician for help.

● Changes or modifications not approved by the party responsible for

   compliance could void user’s authority to operate the equipment.

Содержание OBZ-06CR3







Отзывы: