Oce VL3200x, Руководство пользователя

Страница: 132 / 227

120
Copy difficulties
Difficulties Suggestions
Cannot make a copy. „ Make sure that the Copy key is illuminated. (See Entering copy mode
on page 86.)
„ Contact your administrator to check your Secure Function Lock settings.
Vertical black line appears in
copies. Black vertical lines on copies are typically caused by dirt or correction fluid on the
glass strip, or the corona wire for printing is dirty. (See
Cleaning the scanner
on page 149 and Cleaning the corona wire on page 151.)
Printing difficulties
Difficulties Suggestions
No printout. „ Check that the machine is plugged in and the power switch is turned on.
„ Check that the toner cartridge and drum unit are installed properly. (See
Replacing the drum unit on page 158.)
„ Check the interface cable connection on both the machine and your computer.
(See the
Quick Setup Guide .)
„ Check that the correct printer driver has been installed and chosen.
„ Check to see if the LCD is showing an error message. (See Error and
maintenance messages on page 133.)
„ Check that the machine is online:
(Windows Vista
®
) Click the Start button, Control Panel ,
Hardware and Sound , and then Printers . Right-click Oce VL3200x Printer .
Make sure that Use Printer Offline is unchecked.
(Windows
®
XP and Windows Server
®
2003) Click the Start button and choose
Printers and Faxes . Right-click Oce VL3200x Printer . Make sure that
Use Printer Offline is unchecked.
(Windows
®
2000) Click the Start button and choose Settings and then
Printers . Right-click Oce VL3200x Printer . Make sure that
Use Printer Offline is unchecked.
„ Contact your administrator to check your Secure Function Lock settings.
The machine prints unexpectedly
or it prints garbage. „ Pull out the paper tray and wait until the machine stops printing. Then turn off
the machine’s power switch and disconnect from the power for several
minutes. (The machine can be turned off for approximately 60 hours without
losing faxes stored in the memory.)
„ Check the settings in your application to make sure it is set up to work with your
machine.
„ If you are using the parallel port connection, check that the port is BRMFC and
not LPT1.
The machine prints the first couple
of pages correctly, then some
pages have text missing. „ Check the settings in your application to make sure that it is set up to work with
your machine.
„ Your computer is not recognizing the machine’s input buffer’s full signal. Make
sure that you connected the interface cable correctly. (See the
Quick Setup
Guide .)
The headers or footers appear
when the document displays on
the screen but they do not show up
when it is printed. There is an unprintable area on the top and bottom of the page. Adjust the top and
bottom margins in your document to allow for this.