Oce VarioPrint 6000 MICR series, Руководство пользователя по эксплуатации

Страница: 145 / 264

Perform a media registration for standard-size media
Introduction
The different properties of media can influence the alignment of images when the media
are printed. To ensure a correct alignment, you can perform a media registration for each
individual media in the 'Media catalog'. The following values will be measured.
• The Z-position of side 1
• The X-length of side 1
• The Z-position of side 2
• The X-position of side 1
• The X-position of side 2.
For each media registration, a paper ruler and 3 test sheets will be printed. Depending
on the regional setting in the Settings Editor, the paper ruler is printed on A4 or Letter.
You can use the first printed sheet to create the paper ruler. However, you can also use a
universal ruler of your own. The ruler must be long enough to carry out the measurements.
You must carry out each measurement on all 3 test sheets. The system calculates the av-
erage value of the measurements.
This section describes how to perform a media registration for standard-size media (media
with a length of less than 390 mm / 15.35").
Note:
It is recommended to perform the media registration when the list of 'Scheduled jobs'
is empty.
Before you begin
1.
On the operator panel, press the 'System' button.
2.
Press 'Media'.
3.
Select a media from the 'Media catalog' for which you want to perform a media registra-
tion.
4. Press 'Registration'.
When a maintenance PIN is defined in the Settings Editor, a numerical keyboard appears.
5.
Enter the maintenance PIN to start the wizard.
Note:
The following procedures often refer to the start of the ruler. The start of the ruler is
the line where the shaft of the arrow starts.
Chapter 5 - Working with the operator panel 145
Perform a media registration for standard-size media