Oce VarioPrint 2045-65 NC, Руководство по эксплуатации

Страница: 66 / 213

64 Océ VarioPrint 2045-65 NC Job Manual
Stop or correct a print job
Introduction
A print job has the following phases (see ‘ Print jobs in this manual ’ on
page 32 ):
1
The job is stored in the mailbox on the DAC.
2
The job is printed when you print the job on the operator panel (mailbox job).
The job is printed when the job reaches the top of the print queue (automatic
job).
The table below displays the actions to take if you stop or correct a phase.
Note:
You can interrupt the copy process before it has finished in order to start
a new job. The suspended job is continued after the new job is completed (see
‘Interrupt a print job’ on page 66).
Note:
You can delete jobs from the mailbox in order to prevent the mailbox from
becoming full (see ‘Control the mailbox jobs’ on page 56).
Correcting: when you make the print job settings
If Then
You notice an incorrect setting for
the mailbox job Correct the mailbox job setting.
You want to start a job while the jobs
from the print queue are being print-
ed Stop the printing of the print queue.
The printed sets are incorrect and the
job is not yet completed (phase 2) Stop the printing process.
If you press the correction key Then
Once The Océ VarioPrint 2045-65 NC re-
stores the settings as defined in the
Océ VarioPrint 2045-65 NC printer
driver.