Oce PP18C, Руководство по эксплуатации

Страница: 79 / 150

Using the Operator Panel
ADVANCED OPERATION GUIDE 2-53
Writing Data
Data can be written to a memory card until the card is full. When writing to
a memory card, a name is assigned to the file automatically. You can use
the procedure explained in the section
Printing a List of Data Names
(Partitions) on page 2-56 to print a list of data names for confirmation.
NOTE:
First check that the memory card is properly formatted.
Otherwise, the
>Write Data
message to be explained below will not be
shown on the message display. If the memory card inserted in the
memory card slot is not formatted,
>Format
will automatically appear on
the message display. Format the memory card. See Formatting a Memory
Card on page 2-55 .
1
Press [MENU] .
2 Press
U
or
V
repeatedly until
Memory
Card >
appears.
3 Press
Z
.
4 Press
U
or
V
repeatedly until
>Write
Data
appears.
5 Press [OK] ([ENTER]) . A question mark (
?
)
appears.
6 Press [OK] ([ENTER]) .
Processing
appears, then
Waiting
.
7 Send the file from the computer to the printer.
As the printer receives data, the message display changes to
Processing
, then when the end of the data is received, the message
display changes to
Waiting
.
8 Check that the message display has changed to Waiting, then press [GO] .
This writes the file to the memory card and instructs the printer to
automatically print out a memory card write information page as shown
below.
The file is written onto the memory card given a destination name (also
referred to as a partition name) which the printer automatically assigns one
Memory Card >
>Write Data
>Write Data ?