Oce PP18C, Руководство по эксплуатации

Страница: 56 / 150

Using the Operator Panel
2-30 ADVANCED OPERATION GUIDE
8 Press
U
or
V
to scroll through the following communication modes:
• Nibble (high)
• Auto
• Normal
• High Speed
9 When the desired communication mode is displayed, press [OK]
([ENTER]) .
10 Press [MENU] to exit the menu selection.
Changing Serial Interface Parameters (FS-C5030N only)
NOTE:
This section applies to the printer having the optional serial
interface board kit (IB-11) installed.
You can confirm or change the serial interface parameters including baud
rate, data bits, stop bits, parity, and protocol. These parameters must
match those of the computer’s serial interface.
1 Press [MENU] .
2 Press
U
or
V
repeatedly until
Interface >
appears.
3 If the interface is other than serial, press
[OK] ([ENTER]) . A blinking question mark
(
?
) appears.
4 Press
U
or
V
repeatedly until
Serial
appears.
5
Press [OK] ([ENTER]) again.
6
Press
Z
. One of the following serial parameters is indicated (
Baud rate
for example).
Interface
? Parallel
Interface
? Serial