Oce PP18C, Руководство по эксплуатации

Страница: 111 / 150

Using the Operator Panel
ADVANCED OPERATION GUIDE 2-85
5 Press [OK] ([ENTER]) . A blinking question
mark (
?
) appears.
6 Select
On
or
Off
using
U
or
V
.
7 Press [OK] ([ENTER]) .
8 To exit the menu selection, press [MENU] . The display returns to
Ready
.
Setting the Error Clear Time
1 Press [MENU] .
2 Press
U
or
V
repeatedly until
Others >
appears.
3 Press
Z
.
4 Press
U
or
V
repeatedly until
>Auto
Error Clear >
appears.
5 Press
Z
and display
>>Error Clear
Timer
. The default setting is
30
seconds.
6
Press [OK] ([ENTER]) . A blinking cursor (
_
)
appears.
7
Press
U
or
V
to increase or decrease the value at the blinking cursor and
set the desired time. The time must be set between
000
and
495
seconds,
in 5-second increments. If set to
000
, printing will be continued
immediately without any time interval. You can use
Z
and
Y
to move the
cursor right and left.
8
Display the desired time and press [OK] ([ENTER]) .
9
Press [MENU] . The display returns to
Ready
.
Duplex Printing Error Detection Setting
If the error detection setting for duplex printing has been turned
On
, and
you attempt to print onto a paper size and paper type that cannot be used
for duplex printing, the
Duplex disabled Press GO
error message will
>Auto Error
Clear ? Off
Others >
>Auto Error >
Clear On
>>Error Clear
Timer 030sec.
>>Error Clear
Timer 030sec.