Oce CS 5070, Руководство пользователя

Страница: 27 / 139

Getting started 27
Installing ink cartridges
The process of installing new ink cartridges involves the following phases:
■
Placing the cartridges on the carriage
■
Priming the ink delivery lines
■
Printing a colour test
Attention:
The Océ CS 5050/5070 works only with Océ pre-filled ink
cartridges. Using other cartridges can damage the printer and/or prevent
the printer from printing.
Placing the cartridges
When you place the cartridges, follow these precautions closely:
■
Do not remove the blue tape from the cartridge until instructed to do so.
■
Do not touch the jet area or the flex contact area of the cartridge.
■
Work with only one colour at a time to avoid mixing.
■
Make sure that the ink delivery lines are not twisted.
▼ ▼ ▼ ▼
To place a cartridge
1
With the printer powered on, press
Utility/Access Cartridges
to move the
carriage into position for cartridge installation or replacement.
2
The cartridges are pre-filled and pre-primed. Remove the cartridge from the
sealed bag and remove the shipping cap.
3
Place it bottom first into the correct slot on the carriage.
Note:
Do not remove the blue tape from the jet plate.
4
Tilt the cartridge up until it clicks into place. Make sure the cartridge is firmly
installed.
Priming the ink delivery lines
After filling the ink reservoirs, prime each of the four ink delivery lines to
establish ink flow between the reservoirs and cartridges. Use the Océ 5350
Prime tool for this purpose. The Prime tool is a battery operated ink priming