Oce Arizona 250 GT, Руководство пользователя

Страница: 115 / 178

115
How to Unload and Cut Media
How to Unload and Cut Media
Introduction
This section explains all of the actions associated with how to cut and unload media
when there is still some media left on the supply roll.
Note: If the media supply roll is empty, simply remove the empty supply shaft and
the take-up shaft. Then replace the roll of media from the take-up position with a new
roll and put the shaft into the supply position. Then you can use the empty core from
the supply position as the take-up shaft.
Unload Media Summary
The following actions are associated with unloading media:
1.
Position (Unload) and Cut Media
2.
Remove Media from Take-up Shaft in Printer or Remove Take-up Shaft
3.
Remove Supply Shaft From Printer
4.
Remove Media Roll Or Empty Core From Media Shaft
When to do
This procedures details the actions required when there is still some media left on
the supply shaft. When the supply shaft is empty there is no need to cut or rewind the
media.
Required tool
5mm hex key
A: Position And Cut Media
1.
Click on the Roll Manager icon to bring up the Roll Media Manager.
2.
Select the Unload icon in the Roll Media Manager to automatically position and then
release the tension on the media so it can be cut.
3.
Cut the media using a blade over the cut guide.
4.
Click on OK to proceed.
B: Remove Media from the Take-up Shaft in Printer or Remove Take-up Shaft
1.
If there are only a few images on the take-up roll and you want to remove them
without removing the take-up roll from the printer you can press the left pedal to
rotate the take-up media shaft in the reverse direction. You can then roll up the media
by hand as comes off the take-up roll.