Objet Alaris30, Руководство пользователя

Страница: 104 / 142

Operating & Maintaining the Objet30 3-D Printer
7–24
DOC-24000 Rev. C
Pattern Test
The pattern test is the basic verification of the printer’s ability to produce
quality models, since it demonstrates the condition of the nozzles in the
print heads. Make sure, therefore, that you perform this test weekly, and
whenever you suspect a printing problem.
To perform the pattern test:
1. Make sure that the build tray is empty.
2. Prepare a sheet of pink paper, approximately 21 × 14 centimeters in
size (8.5 × 5.5 inches)—half of the standard A ‐ 4 or Letter size.
3. In the Objet30 printer, tape the pink paper to the center of the build
tray.
4. Press
F3
, or open the Options menu and select
Pattern Test
.
Figure 7-30: Pattern Test confirmation
5. In the following dialog box, click
No
.
Figure 7-31: Build tray (Z) level adjustment
The Objet30 printer prints a series of lines on the test paper.
Figure 7-32: Sample Pattern Test
6. Carefully inspect the test paper to see if there are missing lines.
Lines printed by
model-material
print head Lines printed by
support-material
print head