Obihai OBi110, Руководство администратора

Страница: 100 / 202

Copyright 2010-2012 Obihai Technology, Inc. 100
X_InboundCallRoute Routing rule for directing incoming calls on this service. The
default rule is to send all incoming calls to the PHONE port (ph).
See
OBi Call Routing and Digit Map Section for a description of
the syntaxes for specifying this parameter
ph
X_RegisterEnable Enable registration for this line. If set to YES, device sends
periodic SIP REGISTER to the service provider according to the
settings in the ITSP Profile. Otherwise, device does not send any
SIP REGISTER for the service Yes
X_KeepAliveEnable Enable sending keep alive message. If set to YES, device sends
periodic keep-alive messages to the destination specified in
X_KeepAliveServer and X_KeepAliveServerPort, at the interval
specified in X_KeepAliveExpires. The content of this message is
the ASCII string “keep-alive\r\n” No
X_KeepAliveExpires Keep alive period in seconds 15
X_KeepAliveServer Hostname or IP address of keep alive server
X_KeepAliveServerPort UDP port of the keep alive server 5060
X_KeepAliveMsgType The type of keep alive messages to send out periodically if keep-
alive is enabled. It can be one of the following choices:
- keep-alive: The string “keep-alive”
- empty: A blank line
- stun: A standard STUN binding request; device will use the
binding response to form its contact address for
REGISTRATION
keep-alive
X_UserAgentPort UDP port where the device sends and listens for SIP messages 5060
DirectoryNumber Directory number associated with this service
X_DefaultRing Default ring pattern number to ring the PHONE port for incoming
calls on this trunk that are routed to the PHONE port according
to the InboundCallRoute of this service. The ring pattern is taken
from the selected Ring Profile. Valid choices are 1-10 1
X_CallOnHoldRing Pattern to ring PHONE port when holding a call on this trunk that
has been connected to the PHONE port. Typically this is a very
short distinctive ring pattern that serves as a reminder to the
user that a call is being on hold. The ring pattern is taken from
the selected Ring Profile. Valid choices are: NO Ring, or 1-10 8
X_RepeatDialRing The ring pattern number to use to ring the PHONE port when a
repeat dial operation on this trunk is successful as the called
party is either ringing or answered 5
X_BargeInRing Call Waiting Ring pattern to ring the PHONE port when the
incoming call is requesting to barge-in. This is applicable in a
call-waiting scenario on the PHONE port 4
X_CallParkedRing Ring pattern to ring the PHONE port only as a reminder that
there are some calls parked in the parking lot. This feature is
applicable only in an OBiPLUS solution. 10
X_SIPDebugOption Enable sending of SIP signaling debug information to the syslog
server (if one is configured on the device). Available choices are:
Disable (do not send SIP signaling debug information) Disable