Obihai OBi100, Руководство администратора

Страница: 148 / 220

Copyright 2010-2013 Obihai Technology, Inc. 148
otherwise.
This option is only available on the OBi110 and devices
with an attached OBiLINE USB to FXO adapter accessory.
EnablePHONEPortBargeIn Enable the caller to barge in when he calls the other
phone port from this phone port while the other phone
port has an active call in progress, on-hold, or ringing.
This option is only available on the OBi202/OBi302 Yes
EnableDoubleHookFlash A double hook flash event is two successive hook flash
events that are less than 700ms apart (by default). If this
event is enabled, the device will generate a hook flash
signal on the PSTN line if the phone is currently on a call
on the line. This option is useful only if
HookFlashHandling is set to “Handle Hook Flash Locally”.
This option is only available on the OBi110 and devices
with an attached OBiLINE USB to FXO adapter. Yes
UseForPagingOnly Enables the OBi to be used for paging only when the
PHONE port is connected to an external PA system (via a
RJ11 to line out connector, available from many
electronics shops). In such configuration the PHONE port
is expected to be “off-hook” all the time; the OBi will
automatically answer an incoming call and will not accept
call-waiting. No
TransferWhenHolding This option provides a short cut to transfer a call to a fixed
pre-configured number without dialing it. If a valid
number is specified for this parameter, the OBi will
transfer the call to the given number when the phone
hook flashes and then on-hook (which would normally
leave the call holding if this parameter is not specified).
The valid number should be a complete number with
trunk information, such as SP1(14083334567).
EndHoldingCallWhenHangUp If this option is enabled, when a user hangs up while a call
is still on hold, the OBi will end that call instead of alerting
the same to the user (with a short ring). No
MOHServiceNumber The number to call to get music streamed to the remote
party when the remote party is placed on hold.
Note: Option not available on the OBi100 and OBi110
PlaySITOnCallFailureCodes A list of (3-digit) error response codes on outbound calls
to trigger SIT w/ optional announcement of the error. OBi
plays fast busy tone w/o any announcement for all other
call failure codes. The codes must be specified collectively
as a digit map.
Note: Option not available on OBi100 and OBi110
([4-9]xx)
PlaySITWithAnnoucement Enable this option to include announcement of the error
when an outbound call has failed
Note: Option not available on OBi100 and OBi110
Yes
Timers
HookFlashTimeMax Hook Flash is a quick transition of the phone’s hook 900