2
HOOKUP
--------------------------------------------------------------------------
POWER
The DMX comes from the factory set to operate on 115 Volts. If the
local power is 220-240 Volts, you will need to change the power
selection switch inside the DMX. Remove the two screws at the
front of the chassis and then lift up the front panel. You will
find the power selection switch on the right side, behind the
transformer.
For 100-120 Volt operation, switch it to "115". For 220-240 Volt
operation, set the switch to "230". Close the lid and replace the
screws.
SIGNAL
Connect either the LEFT and RIGHT, or the MONO outputs to your
amplifier or mixer. The slide pots on the front panel control the
relative volumes of each drum voice in the mixed outputs. Each
voice has its own output as well; these are useful if you are
connecting the DMX to an external mixer. The volume controls have
no effect on the level of the individual outputs, so it is possible
to use the SNARE and BASS individual outputs, for example, and the
mixed outputs for the other voices (turning the SNARE and BASS
VOLUME controls to minimum to remove them from the mixed outputs).
