Oasis Aquatics SmartChem, Инструкция по установке и эксплуатации

Страница: 7 / 25

Oasis SmartChem - INSTALLATION AND OPERATION MANUAL Page 6 of 22
Base Plate
•
The Injection Manifold has been installed into the pipework.
o
Please ensure that a blanking cap is installed on the un-used injection port to prevent
water leaking.
• The injection hose has been installed between the peristaltic pump and the Injection Manifold.
o
Allow a little extra tubing length in case the injection tubing needs to be trimmed at a
later stage.
HINT: Soak the ends of supply and injection hoses in hot water for 30 seconds to soften them, this will
make it easier when fitting the tubes to the pump barbs.
The lid kit has been installed into the bottle/tub of Pool Acid.
IMPORTANT: Always store Pool Chemicals in a well-ventilated position in accordance to the
relevant Dangerous Goods Codes and Standards, to prevent fume build-up, and at least 1.8M
away from your pool equipment so as to not cause corrosion damage of your pool equipment.
Supply Hose
– Goes
from lid of the Pool
Acid bottle or tub to
this side of the pump.
Injection Hose
– goes
from this side of the
pump to the Injection
Manifold.