4
rePAir ProceDUreS
No PoWer or LooSe coNNecTioN
1.
Check the outlet to be sure that it has power and that the power cable is plugged in.
2.
Be sure the red knob is pulled out on the emergency stop.
((See photo below.)
Turn knob clockwise to
release from off position.
))
3.
Check to see if the green light is lit on the control box.
(See photo below)
4. Check all connections on the control box of the table.
(See photo below)
5.
Make sure that all male and female connectors are firmly pushed into each other. Even a slight
misconnection can cause possible difficulty.
(See photo below)
Power Cord
Control box
Green Light
(if the green light
is not lit the table
will not work!)
You must LooK
straiGHt iN oN
tHe LiGHt, to see
it’s GLoW…
Ground Wire
b
Junction
box Plug
emergency
stop button
A
Hand
Control Plug
strain relief
#4
Column
Head end plug
#2
Column
Head end plug
