NXP Semiconductors PCF85063TP-ARD, Руководство пользователя, Страница: 10 / 24

NXP Semiconductors
UM11705
PCF85063TP-ARD evaluation board
Figure 2. PCF85063TP-ARD Jumper locations
Ref Des Test point / jumper label Description
TP1 CLK OUT CLKOUT (pin 7) of PCF85063TP
TP2 INT INT (pin 3) of PCF85063TP
TP3 SDA SDA (pin 5) of PCF85063TP
TP4 SCL SCL (pin 6) of PCF85063TP
TP5 VCC_3V3 3.3 V power rail
TP6 VCC_5V0 5 V power rail
TP7 VCC_3V3_MAIN 3.3 V – MAIN power rail
TP8 VCC_3V3_RTC 3.3 V – RTC power rail
TP9 GND Ground
TP10 GND Ground
TP11 VCC_Main VCC – MAIN power rail
Table 4. PCF85063TP-ARD test points
5 Installing and configuring software tools
PCF85063TP-ARD evaluation board is designed and built as a daughter board able to
work in conjunction with a mother board equipped with an Arduino port. The board was
built to be fully compatible with the following NXP Evaluation (EVK) boards:
• IMXRT1050 EVK Board
•
LPCXpresso55S69 Development Board
• i.MX 8M Mini LPDDR4 EVK Board
Each evaluation/development board benefits by firmware support which can be
downloaded from NXP company site ( www.nxp.com/ ). Before starting, the EVK
motherboard must be programmed with the corresponding firmware package.
Additionally, a GUI application (Windows 10) is available for download from the NXP
site, allowing rapid testing and operation of PCF85063TP-ARD daughter board through
the one of above mentioned EVK. The GUI application is common for all three EVKs
UM11705 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2021. All rights reserved.
User manual Rev. 1.0 — 19 November 2021
10 / 24