NXP Semiconductors
UM11763
PCA9617ADP-ARD user manual
3.2 Assumptions
Familiarity with the I
2
C bus is helpful but not required.
3.3 Static handling requirements
CAUTION
This device is sensitive to ElectroStatic Discharge (ESD). Therefore care
should be taken during transport and handling. You must use a ground strap
or touch the PC case or other grounded source before unpacking or handling
the hardware.
3.4 Minimum system requirements
This evaluation board requires a Windows PC workstation. Meeting these minimum
specifications should produce great results when working with this evaluation board.
•
Computer with Windows 10
•
One USB port (either 3.0 or 2.0 or 1.1 compatible)
•
One of three EVK boards (MIMXRT1050-EVK, LPC55S69-EVK, 8MMINILPD4-EVK)
along with the associated firmware/GUI software
•
USB cable for power and data connection between PC and EVK board (if not included
in the EVK package)
4 Getting to know the hardware
4.1 PCA9617ADP-ARD features
•
Equipped with I
2
C EEPROM for rapid test and measurements;
•
Equipped with programmable power supplies for logic level combination;
•
Onboard I
2
C-bus connector for easy access from external;
•
Onboard jumpers for signal isolation of the DUT;
•
Equipped with Arduino Uno R3 port for direct connection with Arduino devices;
•
Fully compliant with IMXRT1050 EVK board, including GUI (Windows 10);
•
Fully compliant with LPCXpresso55S69 dev. board, including GUI (Windows 10);
•
Compliant with i.MX Mini LPDDR4 EVK board, including GUI (Windows 10).
Note: For i.MX Mini LPDDR4 EVK Board it is necessary to use an IMX8MMINI-IARD
interposer board between the EVK and PCA9617ADP-ARD daughterboard (see
IMX8MMINI-IARD User Manual).
4.2 Kit featured components
identifies the main components on the board. The PCA9617A (U6) is placed
in center of the board. In the right side, the user can find the EEPROM (U10) and the
hardware address jumpers (J11, J16, J17) of the DUT (U6). The output enable jumper
(J14) and I
2
C-bus external connector (J3) are in the bottom side. The programmable
power supplies (LOD 1, LDO 2), along with its additional components, are placed in the
top side of the PCB. Here, the user can find the power LEDs (D1-3.3 V, D2-5 V) and LDO
enable LED (D3).
UM11763
All information provided in this document is subject to legal disclaimers.
© 2022 NXP B.V. All rights reserved.
User manual
Rev. 1.0 — 22 July 2022
5 / 25