WCT1012VLF/WCT1013VLH Consumer MP-A11 (WCT-
15W1CFFPD) V1.0 Wireless Charging Application User’s
Guide, Rev. 1, 05/2019
20
NXP Semiconductors
•
“Calibration”—a group of parameters for calibration of the input current, input voltage, and
foreign objects detector.
The meaning of each parameter is described next to the text field.
NOTE
The parameters of the “Calibration” tab can be changed at
run-time, but the parameters of the “Op Params” tab cannot take
effect immediately. To modify the parameters in the “Op Params”
page: enter the debug mode, modify the parameters, and exit the
debug mode. The parameters can then take effect.
6. Application monitoring using console
The application sends some information and error states through the SCI to the console. The information
is sent when the board is turned on, when the device is charging, or in case of an error state.
On the MP-A11 design, only one SCI port (SCI0) is available on the J4 connector. SCI0 is used for
FreeMASTER by default. Select an alternative method to enable the debug console.
1.
Disable FreeMASTER and configure the SCI0 as the debug console.
a)
#define DEBUG_CONSOLE_SUPPORTED
(TRUE)
#define FREEMASTER_SUPPORTED
(FASLE)
The macros are defined in
example->wct101xa–>configure-> appcfg.h
.
b)
#define QSCI_CONSOLE_INDEX 0
#define QSCI_FREEMASTER_INDEX 1
The macros are defined in
example->wct101xa->driver->qsci.h
.
c)
gWCT_Params.tDebugConfig.bGeneralDbg = 1;
This variable is in
wct_LibParams.c
.
2.
Change the FreeMASTER communication interface to JTAG and configure the SCI0 as the debug
console.
a)
#define DEBUG_CONSOLE_SUPPORTED
(TRUE)
#define FREEMASTER_SUPPORTED
(TRUE)
The macros are defined in
example->wct101xa–>configure-> appcfg.h
.
b)
#define QSCI_CONSOLE_INDEX 0
#define QSCI_FREEMASTER_INDEX 1
The macros are defined in
example->wct101xa->driver->qsci.h
.
c)
#define FMSTR_USE_SCI 0 /* To select SCI communication interface */
#define FMSTR_USE_JTAG 1 /* 56F8xxx: use JTAG interface */