NXP Semiconductors MKW01Z128, Справочное руководство

Страница: 463 / 884

19.4.3 Dual-Address Data Transfer Mode
Each channel supports dual-address transfers. Dual-address transfers consist of a source
data read and a destination data write. The DMA controller module begins a dual-address
transfer sequence after a DMA request. If no error condition exists, DSRn[REQ] is set.
• Dual-address read—The DMA controller drives the SARn value onto the system
address bus. If DCRn[SINC] is set, the SARn increments by the appropriate number
of bytes upon a successful read cycle. When the appropriate number of read cycles
complete (multiple reads if the destination size is larger than the source), the DMA
initiates the write portion of the transfer.
If a termination error occurs, DSRn[BES, DONE] are set and DMA transactions stop.
• Dual-address write—The DMA controller drives the DARn value onto the system
address bus. When the appropriate number of write cycles complete (multiple writes
if the source size is larger than the destination), DARn increments by the appropriate
number of bytes if DCRn[DINC] is set. BCRn decrements by the appropriate number
of bytes. DSRn[DONE] is set when BCRn reaches zero. If the BCRn is greater than
zero, another read/write transfer is initiated if continuous mode is enabled
(DCRn[CS] = 0).
If a termination error occurs, DSRn[BED, DONE] are set and DMA transactions
stop.
19.4.4 Advanced Data Transfer Controls: Auto-Alignment
Typically, auto-alignment for DMA transfers applies for transfers of large blocks of data.
As a result, it does not apply for peripheral-initiated cycle-steal transfers.
Auto-alignment allows block transfers to occur at the optimal size based on the address,
byte count, and programmed size. To use this feature, DCRn[AA] must be set. The
source is auto-aligned if DCRn[SSIZE] indicates a transfer size larger than
DCRn[DSIZE]. Source alignment takes precedence over the destination when the source
and destination sizes are equal. Otherwise, the destination is auto-aligned. The address
register chosen for alignment increments regardless of the increment value. Configuration
error checking is performed on registers not chosen for alignment.
If BCRn is greater than 16, the address determines transfer size. Transfers of 8 bits, 16
bits, or 32 bits are transferred until the address is aligned to the programmed size
boundary, at which time accesses begin using the programmed size. If BCRn is less than
16 at the start of a transfer, the number of bytes remaining dictates transfer size.
Functional Description
MKW01Z128 MCU Reference Manual, Rev. 3, 04/2016
332 Freescale Semiconductor, Inc.