NXP Semiconductors MC9S08LG16, Справочное руководство

Страница: 52 / 373

Chapter 4 Memory
MC9S08LG32 MCU Series, Rev. 5
52 Freescale Semiconductor
4.4 Register Addresses and Bit Assignments
The register groups in the MC9S08LG32 series consist of the following locations in the memory map:
• Direct-page registers are located at the first 96 locations. Access these locations with efficient
direct addressing mode instructions.
• LCD Registers, LCDPENx, LCDBPENx, LCDWFx are located at the end of the RAM module.
• High-page registers are used much less often, so they are located above 0x1800 in the memory
map. This leaves more room in the direct page registers for more frequently used registers and
RAM.
• The nonvolatile register area consists of a block of 16 locations in flash memory at
0xFFB0–0xFFBF. Nonvolatile register locations include:
— NVPROT and NVOPT are loaded into working registers at reset
— An 8-byte backdoor comparison key that optionally allows controlled access to secure memory
Because the nonvolatile register locations are flash memory, they must be erased and programmed
like other flash memory locations.
Direct-page registers can be accessed with efficient direct addressing mode instructions. Bit manipulation
instructions can be used to access any bit in any direct-page register.
Table 4-2
is a summary of all
user-accessible direct-page registers and control bits.
The direct page registers in Table 4-2 can use the more efficient direct addressing mode, which requires
only the lower byte of the address. Because of this, the lower byte of the address in column one is shown
in bold text. In
Table 4-4 and Table 4-5 , the whole address in column one is shown in bold. In Table 4-2 ,
Table 4-4 , and Table 4-5 , the register names in column two are shown in bold to set them apart from the
bit names to the right. Cells that are not associated with named bits are shaded. A shaded cell with a 0
indicates this unused bit always reads as a 0. Shaded cells with dashes indicate unused or reserved bit
locations that could read as 1s or 0s. When writing to these bits, write a 0 unless otherwise specified.