NXP Semiconductors JN516x-EK001, Руководство пользователя, Страница: 16 / 86

Chapter 1
Introduction to the Evaluation Kit
16 © NXP Laboratories UK 2015 JN-UG-3093 v1.5
1.3.2 Carrier Boards (DR1174)
The four carrier boards (part number: DR1174) are physically identical. They are all
pre-fitted with an Arduino-compatible expansion board and a JN5168-based module,
but they are not all fitted with the same types of expansion board and module - the
hardware configurations of the four Carrier Boards are detailed in Table
1 on page 14 .
Figure 6: DR1159 Remote Control Unit (and DR1128 Programming Dongle)
Note 1: The Carrier Boards are supplied with the correct
hardware configurations for the pre-loaded JenNet-IP
Smart Home Demonstration. Once you have run this
demonstration, you can re-configure the Carrier Boards
as you wish - for example, by replacing a fitted module
with one of the supplied high-power modules and/or
replacing one of the expansion boards with the supplied
LCD Expansion Board.
Note 2: For full details of the board, refer to the Carrier
and Expansion Boards Reference Manual (JN-RM-
2063)
, available from the NXP Wireless Connectivity
TechZone (see “Support Resources” on page 8 ).