© 2018 nVent
89091001
- 3 -
INTRODUCTION
The Remote Access Control is a parametric controller for the complete management of air conditioners. All
settings are pre-programmed at the factory. Cooling/heating set-points, cooling/heating differential and high /low
temperature alarm set-points can be adjusted by the user. Alarms are outputted through a relay contact and also
can be accessed through an Ethernet connection utilizing SNMP, EtherNet/IP, Modbus TCP, and PROFINET. A USB
connection is also provided and can be used to interface with the controller utilizing Modbus RTU.
MOUNTING THE CONTROLLER
The Remote Access Control must be mounted and enclosed inside a tool access enclosure. This Remote Access
Control comes with a DIN rail and a DIN rail mounting bracket; see below for DIN rail mounting dimensions. The
communication ports and alarm input/output terminals are located underneath the Remote Access Control.
When installing, allow sufficient space under the Remote Access Control for access to communication ports and
alarm input/output terminals.
;
5;
;
;
89062967
ENERGIZING THE CONTROLLER
The controller is wired and programmed at the factory to be energized when power is supplied to the air
conditioner. The controller will default to the standalone operating mode when powered the first time. Master-
Slave operating mode is optional and will require additional setup.
CONTROL STATUS INDICATION
The display has numerous symbols that indicate if the controller is heating, cooling, alarming, if the compressor
is enabled, and if the ambient fan is enabled. The 3 alpha-numeric characters further describe alarms and show
the cabinet temperature by default.
NOTE: The Slim Fit air conditioners DO NOT come standard with a heating option.
