2
3. If lamps are not fitted, then:
•
For T5, locate the pins at both ends of the lamp into the lampholders & rotate 90
o
to secure
•
For PLL, align the pins & push-fit into the lampholder then locate the other end into the lamp
support bracket. Now locate the lamp securing device (supplied in separate bag) to each
lampholder.
4. Reconnect power supply & check for correct operation. As these luminaires are fitted with electronic
ballasts they are exempt from insulation resistance tests, as this may cause damage to the ballast.
ATTACHMENT INSTALLATION - PC COVER PANEL OR WIREGUARD
The following installation guide assumes you already have an Oregon luminaire installed as per the
LUMINAIRE INSTALLATION instructions detailed on Page 1:
1. Remove the L shaped attachment bracket (located on end opposite to terminal block) by loosening the
M4 screws, sliding slightly to the side & then pulling away.
2. Slide in the PC cover panel from the end of the luminaire, ensuring the end locates on top of the
support tab at the terminal end of the luminaire.
3. Replace the attachment bracket & tighten the screws to secure in place.
MAINTENANCE
1. Any failed lamps should be replaced promptly to avoid irreparable damage to the luminaire.
2. Lamps should be replaced on a planned maintenance schedule.
3. Cleaning should be carried out at regular intervals so as not impair photometric performance or
thermal safety of the luminaire.
WARNING: Ensure luminaire is switched off & suitably cooled down before carrying out any
maintenance work
