NuMaker RTU NUC980
May.
22, 2020
Page
5
of 33
Rev 1.00
NUMA
K
E
R
RT
C
NUC9
80
US
E
R
M
A
NU
A
L
Ma
k
er Nu
-m
be
d
NUC
47
2
Us
er Man
ua
l
1
OVERVIEW
This document provides a quick start guide for the NuMaker RTU NUC980 Development Board. Users
can understand both software and hardware configurations for the NuMaker RTU NUC980. The
platform provides Linux OS and plenty of industrial control protocol for users to implement the
Ethernet control applications in a very short time.
The NuMaker RTU NUC980 board uses NUC980DR61YC microprocessor run up to 300 MHz with
built-in 64MB DDR2 memory, 16 KB I-cache, 16 KB D-cache and MMU, 16 KB embedded SRAM and
16.5 KB IBR (Internal Boot ROM) for system booting from USB and SPI flash, all functions of the
NUC980DR61YC are placed on the board, including peripheral interfaces such as SPI Flash memory,
UART, 10/100 Mb Ethernet MAC controller, high speed USB (Device, Host), JTAG, RS485 and CAN
transceiver controller. Users can use it to develop and verify applications to emulate the real behavior.
Figure 1-1 NuMaker RTU NUC980 Development Board