10
EN
TECHNICAL OWNER MANUAL
NFINITY
ASSEMBLY OF COMPONENTS
A
B
C
D
•
(for chainline and beltline
specifications)
•
The
NuVinci Optimized
CVPs are
compatible with 16 to 28 tooth sprockets.
for sprocket ratio
requirements and approved gearing
3.
If a
Nfinity
Hub Interface is not installed
immediately following the sprocket, replace
the anti-shift retainer (
A
)
3.2 Installing the Sprocket
1.
Remove the anti-shift retainer (
A
) by pulling
firmly away from the
NuVinci
CVP
2.
Install a standard 9-spline 3/32 inch
(2.3mm) sprocket (
B
) with the flat side
facing the CVP, followed by the supplied
sprocket spacer (
C
, if required), and secure
with the sprocket snap ring (
D
).
•
The sprocket spacer is intended for
sprockets that are 3/32 inch (2.3mm) thick
at the inner diameter. If the inner diameter
is 0.17-0.18 inch (4.3-4.5mm) thick, the
spacer should not be used.
Use of incompatible chains can
result in interference with the
Nfinity
Hub Interface and damage to CVP
components and may result in a dangerous
condition for the rider.
NuVinci Optimized
CVPs are
incompatible with 1/8 inch
(3.18mm) single-speed chains and
sprockets that are flat on at least one side.
Use 3/32 inch (2.3mm) chains and sprockets
only.
If the sprocket is asymmetric, incorrect
installation can result in interference
with the
Nfinity
Hub Interface and
damage to CVP components and may result
in a dangerous condition for the rider.
!
!
!
Nfinity 330
systems are compatible
with mid-motor eBike systems rated
at 250W or less.
for
approved gearing tables.
Nfinity 380
systems are compatible with mid-
motor eBike systems rated at 350W or less.
!
