Package
Overview
Installation
1
2
3
4
►
Connecting
Network
Cable
*
1 It
is
recommended
to
install
the
security cap
for
outdoor installation
.
*
2
If
the PoE switch
is
used
to
power
the
camera
,
DC12V
power supply
is
not
required
.
Warning
and
Caution
Camera
Quick
start
guide
Plastic
plug
×4
Drill
template
Rubber plug
Allen Key
Tapping screws × 4
Before you start, please make sure that the wall or ceiling is strong
enough to withstand three times the weight of the camera. Please install
the camera in a dry environment. Be sure to install the cover or lower
dome back within 4 hours after removing it. Do not remove the protection
film until the installation is completed.
①
Attach the drill template to the place where you want to fix the camera
and then drill the screw holes and the cable hole on the wall according
to the drill template.
②
Rotate the trim ring
counter-
clockwise to remove it from the camera.
2
1
3
■
Please read these instructions carefully before operating the unit
and keep it for further reference.
■
All the examples and pictures used here are for reference only.
■
The contents of this manual are subject to change without
notice.
■
Visit nuvico.com for additional downloads, manuals, and resources.
74.3
74.3
T
rim
ring
(mm)
1
2 Audio input
3
4
5
Ethernet connector
Power
connector
Micro SD Card Slot
Reset
4
1
2
3
5
DC12V
Security C
ap
NCT-
8
ML
2
-OV2
Vandal Dome
Camera
Quick Start Guide
■
If the product does not work properly, please contact your dealer or
the nearest service center. Never attempt to disassemble the camera
yourself. (We shall not be responsible for any problems caused by
unauthorized repair or maintenance.)
■
Do not allow water or liquid intrusion into the camera.
■
In the use of the product, you must be in strict compliance with the
electrical safety regulations of the nation and region. When the product is
mounted on wall or ceiling, the device shall be firmly fixed.
■
Do
not
u se
camera
beyond
specified
voltage
range
.
■
Do not drop the camera or subject it to physical shock.
■
Do not directly touch the camera when installing.
■
Avoid touching the camera lens
.
■
If cleaning is necessary, please use clean cloth to wipe it gently.
■
Avoid pointing the camera towards the sun or other light sources.
■
Do not place the camera in extremely hot, cold (the operating
temperature shall be -22˚F~140˚
F
), dusty or damp locations, and do
not
expose it to high electromagnetic radiation.
■
To avoid heat accumulation, good ventilation is required for
operating
environment.
①
②
Loosen the
nut from the main element.
R
un the network cable (without the RJ45 connector) through
both elements. Then crimp the cable with the RJ45 connector.
③
Connect the cable to the hermetic connector. Then tighten the nut
and the main cover.
