Package
Overview
Installation
1
2
3
4
►
Connecting
Network
Cable
①
Loosen
the
nut
from
the
main
element.
②
Run
the
network
cable (without
RJ 45
connector) through
both
elements. Then
crimp
the
cable
with
RJ 45
connector
.
③
Connect the cable to the hermetic connector. Then tighten the nut
and the main cover.
Warning
and
Caution
■
If the product does not work properly, please contact your dealer
or
the nearest service center. Never attempt to disassemble the
camera
yourself. (We shall not be responsible for any problems
caused by
unauthorized repair or maintenance.)
■
Do not allow water or liquid intrusion into the camera.
■
In the use of the product, you must be
in
strict compliance with the
electrical safety regulations of the nation and region. When the
product is
mounted on wall or ceiling, the device shall be firmly
fixed.
■
Do
not
use
camera
beyond
specified
voltage
range
.
■
Do not drop the camera or subject it to physical shock.
■
Avoid touching the camera lens
.
■
If cleaning is necessary, please use clean cloth to wipe it gently.
■
Do not aim the camera at the sun or extra bright place.
■
Do not place the camera in extremely hot, cold (the operating
temperature shall be
-22
˚
F~14
0˚
F
), dusty or damp locations, and do
not
expose it to high electromagnetic radiation.
■
To avoid heat accumulation, good ventilation is required for
operating
environment.
NCT-5ML-E2 Eyeball Camera
Quick Start Guide
Camera
Quick
start
guide
CD
Plastic
plug
×3
Drill
template
Screwdriver
Tapping screw × 3
③
and then d
the drill template.
Attach the drill template to the place where you want to fix the camera
rill the screw holes and the cable hole on the wall according to
■
Please read th
e
s
e
instruction
s
carefully before operating the
unit
and keep it for further reference.
■
All the examples and pictures used here are for reference only.
■
The contents of this manual are subject to change without
notice.
*
2
If
the
PoE switch is
used
to
power
the
camera that supports PoE power supply,
DC12V
power supply
is
not
required
.
Security C
ap
2
1
3
Network connector
Power
connector
1
2
3
4
5
6
Fixed screw
Micro SD card slot*
Reset*
Mounting base
Fixed Screw
Mounting Base
Enclosure
Dome
1
2
3
4
DC12V
Please make sure that the wall or ceiling is strong enough to
withstand 3 times the weight of the camera.
①
install the cover back to the dome and fix it firmly with the screws.
Note that the cover should not be installed unevenly. (Please skip this
step if your camera has no micro SD card slot).
②
Loosen the fixed screw to disassemble the camera.
Remove the cover from the dome to insert the SD card. Then,
5
6
Cover
Note
: Micro SD card slot and reset are optional. If no such interfaces, please
skip the above-mentioned(5, 6) instructions.
*
1 It
is
recommended
to
install
the
security
cap
for
outdoor installation
.
