10
Figure 2
5.7.
CONTROL PANEL
Figure 3
1-
Heating Process Display:
This display shows the chamber temperature during the operation
and the set temperature value during programming. The error codes are also shown on this
display.
2-
Time Display
: This display shows the elapsed time during the operation and the set time
value during programming.
3-
Alarm Mute Key
: It is a button used to mute the audible alarm in case of error and the
completion of operation time.
4-
Start / Stop Key
: This key is pushed to start the program or to stop the running program
manually.
5-
Temperature Set Key
: This key is used to adjust the temperature value.
6-
Temperature Value Increase and Decrease Keys
: These keys are used to increase or
decrease the values on the temperature display.
7-
Time Set Key
: This key is pushed to set the time. (1 minute – 99.9 hours and Hold
position).The each decimal point shows 6 times of the minute. (Ex. 17.5 = 17 hours 30
minutes)
8-
Time Value Increase and Decrease Keys
: These keys are pushed to increase or decrease the
values on the time display.
9-
Heat Led
: This led flashes during heating process.
10-
Alarm Led
: It is a lamp flashing when the program ends and when any failure occurs during
the operation.
5.8.
PRIOR TO OPERATION
Push the On/Off switch. See that the on/off lamp is turn on.
See that the microprocessor control system activates.
Learn the function of the control panel (See 5.7).
Check that the
safety thermostat value is higher than the set temperature.
