NuTone NTM Series Скачать руководство пользователя страница 1

INSTALLATION INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS

NUTONE R

ANGE

H

OOD

NTM S

ERIES

!

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSON(S) OBSERVE THE FOLLOWING:

1.

Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer at the 
address or telephone number listed in the warranty.

2.

Before servicing or cleaning unit, switch power off at service 
panel and lock service disconnecting means to prevent 
power from being switch on accidentally. When the service 
disconnecting means cannot be locked, securely fasten a 
prominent warning device, such as a tag, to the service 
panel.

3.

Installation work and electrical wiring must be done by qualified
personnel in accordance with all applicable codes and standards,
including fire-rated construction codes and standards.

4.

Sufficient air is needed for proper combustion and exhausting
of gases through the flue (chimney) of fuel burning equipment
to prevent backdrafting. Follow the heating equipment 
manufacturer’s guidelines and safety standards such as 
those published by the National Fire Protection Association 
(NFPA), and the American Society for Heating, Refrigeration 
and Air Conditioning Engineers (ASHRAE), and the local 
code authorities.

5.

When cutting or drilling into wall or ceiling, do not damage 
electrical wiring and other hidden utilities.

6.

Ducted fans must always be vented to the outdoors.

7.

Do not use this unit with any other solid-state speed control 
device.

8

. To reduce the risk of fire, use only steel ductwork.

9

. This unit must be gounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

a)

Never leave surface units unattended at high settings.
Boilovers cause smoking and greasy spillovers that may 
ignite. Heat oils slowly on low or medium settings.

b)

Always turn hood ON when cooking at high heat or when 
cooking flaming foods.

c)

Clean ventilating fans frequently. Grease should not be 
allowed to accumulate on fan or filter.

d)

Use proper pan size. Always use cookware appropriate for 
the size of the surface element.

WARNING

IMPORTANT SAFETY INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS

TO REDUCE THE RISK OF INJURY TO PERSON(S) IN
THE EVENT OF A RANGE TOP GREASE FIRE,
OBSERVE THE  FOLLOWING*:

1.

SMOTHER FLAMES with a close-fitting lid, cookie sheet, or 
metal tray, then turn off the burner. BE CAREFUL TO PRE

V

ENT

BURNS. IF THE FLAMES DO NOT GO OUT IMMEDIATELY,
E

V

ACUATE AND CALL THE FIRE DEPARTMENT.

2.

NE

V

ER PICK UP A FLAMING PAN – You may be burned.

3.

DO NOT USE WATER, including wet dishcloths or towels – 
This could cause a violent steam explosion.

4.

Use an extinguisher ONLY if:

A.

You know you have a Class ABC extinguisher and you 
know how to operate it.

B.

The fire is small and contained in the area where it started.

C.

The fire department has been called.

D.

You can fight the fire with your back to an exit.

* Based on “Kitchen Fire Safety Tips” published by NFPA.

!

WARNING

CAUTION

1.

For general ventilating use only. Do not use to exhaust 
hazardous or explosive materials and vapors.

2.

To avoid motor bearing damage and noisy and/or 
unbalanced impellers, keep drywall spray, construction dust, 
etc. off power unit.

3.

For best capture of cooking impurities, the bottom of the 
hood should be a minimum of 25.6” (27.6” over a gas range) 
above the cooking surface.

4.

To reduce the risk of fire and to properly exhaust air on a 
ducted installation, be sure to duct air outside – Do not 
exhaust air into spaces within walls or ceiling or into attics, 
crawl spaces, or garage.

5.

Please read specification label on product for further 
information and requirements.

HB

00

43

-1-

Содержание NTM Series










Отзывы: