JUMBO 7000 HFK SCISSOR
Nussbaum Automotive Solutions, LP | 1932 Jordache Court, Gastonia, NC 28052 | 704.864.2470 | Email:
18
•
Place a mark at the intersection of the two arcs.
•
Snap a chalk line from the intersection of the arcs to the center point of the existing lifts. This is the “Bay Center
Line
”
10.5.
ESTABLISHING FRONT OR REAR PLATFORM GUIDELINES
Establishing location from the Lift Front
.
Allow 2’ (600mm) for a workbench, 3’ (920mm) for working area and
an additional 6’(1830mm) for the front of the car. This is a total of 11’ (3350mm) from the wall to the front of
the lift platform (excluding ramps). (Fig. 4)
Establishing location from the Lift Rear
.
Allow 10’ (3050mm) from the inside of the
door to the rear of the
platform (excluding ramps) (Fig. 4)
•
Determine the best method above for your application a place a mark on the “Bay Center Line” at the
appropriate location.
•
Measure 4’ (1200mm) down the “Bay Center Line” and place a mark at that point. (Fig. 4)
•
From that mark (established in 5.3.12) draw two, 5’ (1500mm) arcs with the tape measure approximately 3’
(900mm) on both sides of the “Bay Center Line” (
Fig. 4)
Figure 3
Figure 2
Figure 5
Figure 4
Figure 2
Figure 3
