Nussbaum ATT Rugboard, Руководство по эксплуатации, Страница: 38 / 42

38 06.12.07 AD U9001 N
Furthermore, it can be required to change the settings for the
server that the Rugboard is supposed to lock on. This is done in
the server list, where you can find the entry for each server in one
line. Next to server name and IP Address, you can also assign
functions to the rugboard keys for use with this server. Clicking
the 'Properties' button next to that line, you can change extended
settings, like the server password.
4.4.3 Calibration of the Touch Screen
Due to manufacturing tolerances, and over time, it can happen
that the cursor does not appear exactly at the point of the screen
where you tapped with the Stylus. Should this be the case, press
„Calibrate“ in the setup's main menu.
Tap the center of the displayed crosshairs with the stylus. After
this was done in four different positions, there is a plausibility
check, and the new calibration is stored.
4.4.4 Language Selection
In this menu item, you can select the language for all operator
dialogs and menu items of the Rugboard.
4.4.5 Configuration Mode
If the button 'Settings' is not displayed on the start screen, you
can activate it in the configuration mode, so that it will be present
after restarts.
Switch the Rugboard on. During boot, you will see the red
progress bar on the GoWin GOOROO boot screen. As soon as
the progress bar has reached 80% (not before!), you press the
two buttons on the top right corner above the screen (3 and 4),
and keep them depressed, until the page with the progress bar
disappears. You should now see 'Entering Setup...'. In the
following setup menu, you choose 'Network', and there you tick
the 'Allow Setup at Runtime' box. Exit the setup pages. When you
will start the Rugboard the next time, the settings button will be
there at the right bottom of the start screen, as described before.
4.5 Configuration of Access Points (if available)
The two Access points that are available as special accessories,
are preconfigured in the following way:
- 1 987 009 U66N with IP Address 192.168.100.30
- 1 987 009 U67N with IP-Address 192.168.100.31
If you really want to change the settings of these Access Points,
you can use the instructions on the CD that comes with it.
! !
! !
! CAUTION: Do not set the Access points back to their
factory settings, as these will not fit the configuration of
the rugboard.