Nussbaum 2.35 TSK, Инструкция по эксплуатации и документация, Страница: 25 / 35

Operating Instruction and Documentation
2.35 TSK
- 25 -
3. Fill tank with a high quality oil. (Litre and cst. => see chapter 3.1)
C. Test-run
1 . Run the lift a few times (60 cm) up (2') and down without load. Bleed the hydraulic
cylinder. Run the lift a few times fully up and down.
Deaerate the Cylinder:
-
raise the lift on the height of 1988mm
The vent screw is located at the piston rod inside.
- Put a hexagon wrench into the piston rod (see position A)
- Open the hexagon socket screws only one rotation anticlockwise
until air comes out of the cylinder.
- After it, close the screws.
2. Check all hydraulic connections against oil leakage.
3. Check the proper functioning of the locking mechanism and adjust if necessary.
4. Run the lift a few times with full load (up to 3500kg - 7750lbs) and check the proper
functioning of the locking mechanism and the safety lowering stop.
5. Close the top-cover, install the factory supplied sealing and seal the whole with Silicon.
9.3 Initiation
Before the initiation a security check must be performed. therefore use form: First
security check.
If the lift is installed by a competent person, he will perform this security check. If the
operator installs the lift by himself, he has to instruct a competent person to perform the
security check.
The competent confirms the faultless function of the lift in the installation record and form for
the security check and allows the lift to be used.
Please send the filled installation record to the manufacturer after installation.