Nussbaum 2.30 SPL, Инструкция по эксплуатации и документация

Страница: 24 / 42

Operating Instruction and Documentation
2.30 SPL
- 24 -
aggregate for doing that.
After the fill in, the level of the oil must be between the lowest and the highest marking of
the oil level gauge.
• Switch on the main witch.
• Press the button „lifting“.
• Lower automotive lift to lowest position and lift it afterwards 500 - 600 mm. Both
ropes must be tightened lightly. In any other case the self-locking nuts at the upper
side on both carriages must be adjusted again.
Pay attention that each of the two ropes is tightened regularly and that it is
not too slack, otherwise exactly synchronisation can not be guaranteed.
Pay attention that the ropes are not too tight, otherwise there is the
possibility that the lift jerks, or that the lift is too slow while lowering.
The ropes don’t carry load. They must regulate an exactly synchronisation
of the lift.
• Install carrying arms (refer to data sheet), lubricate bolts and secure
them with enclosured circlips at both ends.
Mount a safety plate (Pos. B) in addition, to prevent that the bracket while lowering
to an obstacle will be withdrawn from the bolt. (see picture)
• Raise and lower the automotive lift a couple of times without load in the end
positions. Afterwards raise and lower a couple of times with load in the end positions
9.3 Deaerate the hydraulic-system
• Raise and lower the lift several times in the end positions.
9.4 Initiation
Before the initiation a security check must be performed. Therefore use form: First
security check.
If the lift is installed by a competent person, he will perform this security check. If the operator
installs the lift by himself, he has to instruct a competent person to perform the security check.
The competent confirms the faultless function of the lift in the installation record and form for the
security check and allows the lift to be used.
Please send the filled installation record to the manufacturer after installation.